Reese 59772 ROOF RACK ACCESSORY - Manual

PART No:
Fitting Instructions
APE (Anchor Point Extended)
Cross Bar Kits for Track & Direct
Mounting Systems
CARRYING CAPACITY:
Pg 1 of 3
75Kgs/
165 Lbs
Printed in China
Note: Prior to Assembly
Prior to assembling your cross bar kit check
that the kit contains all the parts you will need
to fit the cross bars. Refer to parts lists for
guidance.
Please read these instructions before assembly.
Step 1: Determine if you have a Direct or
Track mounting roof rack system. These
systems must be installed prior to installing
the cross bar kits. If it’s a Track Mounting
System (part numbers 59853, 59854, &
59855) follow steps 2 and 3. (Fig. 1) If it’s a
Direct Mounting System (part numbers
59753 & 59754) follow steps 4 and 5 (Fig. 2)
Step 2: Installing Cross Bars on a Track Mounting
System.
A.
Locate hardware bag labeled “Track Mount
Hardware”.
B. Assemble bolt M6x16 into End Support and thread
on M6 Hex nut brass onto bolt, (Fig. 3)
Bolt
M8 x 20mm
Qty 4
Clamp Plate
Qty 4
M8 Spring
Washer
Qty 4
M8 Washer
Qty 4
L Wrench
Qty 1
Direct Mount
Bolt M6 x 24mm
Qty 4
M8 Hex Nut
Qty 4
Cross Bar End Caps
Qty 4
13mm or adjustable wrench
Front of
vehicle
Vehicle’s roof
Fig. 1
Fig. 2
Parts list
End Cap Key
Qty 4
59772-3-4N REV 4-24-13
59772, 59773,
59774
Track Systems part numbers
59853 – 59854 - 59855
Direct Systems part numbers
59753 – 59754
End Support
Qty 4
Track Mount
Bolt M6 x 16mm
Qty 4
Cross Bars
Qty 2
Front of
vehicle
Vehicle’s roof
M6 Hex Nut
Brass
Qty 4
Under Cover
Qty 2
Phillips screw driver
Scissors or Blade
Tools required