Alpine CDA-9885 - Manual (Page 16)

14
-EN
01GB05CDA9885.fm
ALPINE CDA-9885 68-08564Z14-A (EN)
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press A.SEL to select the BASS (Bass Center
Frequency) control mode.
Bass Treble HPF Bass
2
-1 Press BAND to select the desired bass center
frequency.
80 Hz 100 Hz 200 Hz 60 Hz 80 Hz
Emphasizes the displayed bass frequency ranges.
2
-2 Press SOURCE/ to select the desired bass
bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
2
-3 * Turn the Rotary encoder to select the desired bass
level (–7~+7).
You can emphasize or weaken the bass level.
3
Press and hold /ESC for at least 2 seconds to
return to normal mode.
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
• Depending on the connected devices, some functions and display
indications do not work. However, Bass Level is still adjustable if an
audio processor with the Bass function is connected.
• The function is inoperable when DEFEAT is set to ON.
* The adjustment can also be made by pressing Rotary encoder
(AUDIO). Refer to “Adjusting Bass/Treble/Balance (Between Left
and Right)/Fader (Between Front and Rear)/Defeat” (page 13).
Setting the Treble Control
You can change the Treble Frequency emphasis to create your own tonal
preference.
1
Press A.SEL to select the TREBLE (Treble Center
Frequency) control mode.
Bass Treble HPF Bass
2
-1 Press BAND to select the desired treble center
frequency.
10 kHz 12.5 kHz 15 kHz 17.5 kHz 10 kHz
Emphasizes the displayed treble frequency ranges.
2
-2 * Turn the Rotary encoder to select the desired
treble level (–7~+7).
You can emphasize or weaken the treble level.
3
Press and hold /ESC for at least 2 seconds to
return to normal mode.
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The treble level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
• Depending on the connected devices, some functions and display
indications do not work. However, Treble Level is still adjustable if
an audio processor with the Treble function is connected.
• The function is inoperable when DEFEAT is set to ON.
* The adjustment can also be made by pressing Rotary encoder
(AUDIO). Refer to “Adjusting Bass/Treble/Balance (Between Left
and Right)/Fader (Between Front and Rear)/Defeat” (page 13).
Setting the Bass Center Frequency
Setting the Bass Bandwidth
Setting the Bass Level
Q1 Q2 Q3 Q4
Setting the Treble Center Frequency
Setting the Treble Level
01GB00CDA9885.book Page 14 Friday, November 17, 2006 7:31 PM