Robertshaw 9520 - Manual (Page 4)

3. Place AUTO-ON switch into AUTO position.
4. Remove the cover using a coin or screwdriver
.
5. Place thermostat against the wall at desired location. Make sure
wires will feed through opening on base of thermostat.
6. Mark placement of mounting holes. See Figure 3.
Set base aside.
Figure 3
7. Drill the marked holes using a 3/16" drill bit. NOTE: Enclosed
plastic anchors do not require a drilled hole for drywall.
8. Tap plastic anchors into the wall.
9. Align base with plastic anchors and feed wires
through opening.
10. Secure base to wall with supplied screws.
4
Figure 2
Batteries NOT Required.
Mounting Holes