Salamander Designs Synergy System SB229C/B - Manual (Page 4)

A
.
Attach Hinges to Door Frames
Insert the hinges into the corresponding holes
on the doors. Turn the screws 1/4 turn to the
right to lock hinges in place. NOTE: Do not over
tighten or the hinge will break.
D
.
Door Pull
Screw the Door Pull into place.
Doors should be 1/8” above the bottom shelf before fully
tightening hinges to post. Use the wrench thickness as a guide
for the bottom gap. Secure hinges in place with hex key. Attach the rubber stops to the
inside of the door frame where
it hits the shelf pegs.
Attach Doors
Note: The hinge can be separated by pulling the
black tab and pulling apart the hinge from the hinge
base. Separated hinges snap back together.
LIFT UP
SHELF
PEG
6
Doc No. 500-615/v8.12 229 -4/4
B
.
Adjust Clearance
C
.
Rubber Stops
A
B
SOFT
CLOSE
INSTALLATION
SLOW CLOSE
FAST CLOSE