Salamander Designs Synergy System SBX/B - Manual (Page 2)

Limited Warranty
For five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any
damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the
original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via
UPS within the continental U.S.A. only.
Salamander Designs Ltd. 800-535-5659 • www.SalamanderDesigns.com
Doc No. 500-370/v2 ©2002 Salamander Designs Ltd. * Diagram: Bridge One & 2 Synergy 30 Base Units
Join the Bridge to the Synergy racks with the connector bolts
and connector nuts. Skip this step if you are installing a Bridge1 or Bridge2 to your unit.
Press the plastic cap plugs into the top 2 center holes of the Bridge3.
3
Attach Bridge
4
Plastic Cap Plugs - Bridge 3 Only
Replace top shelves from Step 1.
Use the bubble level to level Bridge. Remember
to level front to back as well as side to side.
5
Replace Top Shelves & Fine Tune