Salamander Designs Synergy System SN20C/B - Manual (Page 3)

1
B
B
A
A
Leveler Foot
Hex Nut
Washer
90 O
B
.
Connect Post
Screw foot with metal washer
through bottom shelf and onto
the end of an extruded post.
Hand tighten fully then use
wrench on hex nut to tighten
nut onto underside of shelf.
A
.
Square Post
Square the post to the bottom shelf.
B
.
Gently tighten pegs and brackets
with the hex key to desired position.
A
.
Insert all shelf pegs and heavy
shelf brackets (SN40 only)
down each post.
Connect Posts to Bottom Shelf
WARNING: Tighten by screwing the leveler foot NOT the post.
2
Add Shelf Pegs
WARNING: If you are installing an optional door or drawer refer to
specific instructions before proceeding.
! !
Doc No. 500-350 3 of 4