Salamander Designs SA/XR20/AC - Manual

PARTS
Skip steps 1 and 2 if you are not installing active cooling kit.
Use supplied Magnetic Cube to hold
Thermister in place on top of the hottest
piece of equipment closet to the heat
source. Consider your ”always on components”
(i.e. Satelite Receiver, Cable Box).
Note: You can also connect the thermister wire
directly to a component. Loosen screw and slip the
thermister wire under screwhead and tighten.
Plug in the AC adapter located on the top
right of the circuit board, behind the cover.
1X - Allen Key 400-070
4X
Flat Nut
300-560
4X
Washer
300-515
4X
Drop-in Nut
300-565
4X
Thumb Nut
300-530
4X
Stud
300-505
1.
Attach Thermister
2.
AC Adapter
A. Complete 4 hardware assemblies as shown.
B. Slide hardware assemblies loosely into four
outward slots in rear panels aligning drop-in
nuts vertically to fit into extrusion slot.
C. Align rear panel to rear of cabinet and while
pressing into extrusion turn thumbnuts clockwise
to complete the installation.
D. Place heat sensor on component that produces
the most heat. Note: Consider your ‘‘always on
components’’ (i.e. Satelite Receiver, Cable/DVR Box).
LIMITED WARRANTY
Salamander Designs warrants the Cooling Kit against defects in materials and workmanship for a period of two
year from date of purchase. We will repair or replace, at our option, any Cooling Kit which has a defect in materials
or workmanship. The product must be properly packaged and returned prepaid with a Salamander Designs return
authorization number clearly written on the outside of the shipping carton and with a copy of the bill of sale or
Salamander Designs invoice to verify the original purchase date.
Our warranty does NOT apply to:
1. Damage caused by improper installation or improper electrical voltage.
2. Any product which has been modified.
3. Damage caused by corrosion, abrasion, immersion, or severe temperatures.
4. Products which have been subject to abuse, misuse, abnormal usage, or accident.
These warranties give you specific legal rights, and are subject to any applicable consumer protection legislation.
You may also have additional rights which vary from state to state. No other warranties, expressed, implied, or writ-
ten, shall apply to this product. Salamander will not be responsible for any consequential or incidental damages, loss
of property, revenues, or profit, cost of removal, installation, or reinstallation, personal injury, or for any breach of
warranty, regardless of how caused.
© 2008 Salamander Designs Ltd.
Doc. No. 500-395 v.1.10
3.
Install Extended Rear Panel(s)
EXTENDED REAR /
ACTIVE COOLING KIT
MODELS: SA/XR, SAXR/AC
1X
Magnet