Salamander Designs SA/PS - Manual

Doc No. 500-445/v2 ©2002 Salamander Designs Ltd..
Limited Warranty
For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any
damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the
original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via
UPS within the continental U.S.A. only.
Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com
SYNERGY PULL- OUT SHELF
- SA/P S
Parts
1 - Pull-Out Shelf
2 - Shelf Slides
4x
(300-485)
Button Head Screw
4x
(300-560) - Flat Nut
7
8
9
6"
8"
SP
ACER
T
O
O
L
1 . Place the Button Head Screw in the 2 holes of
each slide and attach loosely.
* If you are adding the shelf to an existing rack
use the Drop-In-Nuts (enclosed with instructions).
2 . Insert the Flat Nuts into the channels making
sure that the rollers face the front of the rack.
3 . Use the Spacer Tool (provided with base unit)
to help space the shelf as desired.
4 . Slide shelf into slides. Use the bubble level to
precisely adjust the shelf. Be sure to level both
side to side as well as front to back. Use the
Hex Key to tighten each screw.
4x
1x
(PHK-295)
Easy Drop In Nuts
Hex Key (400-080)