Salamander Designs CL/WK1 - Manual

WALL MOUNT
CHAMELEON
TOOLS REQUIRED
1. Remove top and feet. Install provided connector bolt in previous foot locations.
2. MARK WALL LOCATION
A. WOOD CONSTRUCTION - Using a stud finder, mark the locations of
the studs in the area to be covered by the cabinet. It may be necessary to shift the cabinet
slightly left or right to avoid the mounting brackets being obstructed by the vertical
framework of the cabinet.
Note: It is not important that the brackets are not located in the same relative location in
each bay. As long as a bracket is located every 16” on center sufficient capacity will be met.
B. MASONRY CONSTRUCTION - Mark the wall 2” inward from each
side panel and 2” left or right of each divider panel.
16 16
2”
Pencil
Tap Measure
Connector Bolt
(300-540)
Plastic Wall
Plug
Bracket
(303-850)
Lag Screw Washer
6 mm Hex Key
Leveling Set Screw
(300-540)
Stud Finder Drill and Bit:
3/16” (5 mm) for Wood
3/8” (10 mm) for Masonry
Level
COMES WITH
BEFORE YOU BEGIN
• This bracket is intended for use with Chameleon 20” Tall Cabinets.
• Total weight capacity of each bracket is: 100 lbs. (45kg). (ex 3 brackets provides
300 lbs. (135kg).
• Carefully inspect your items for shipping damage or missing parts. If any damage is apparent or you are
missing parts contact Salamander Designs Ltd. at 800-535-5659.
• Read ALL assembly instructions before assembly. If you have any questions, please contact your installation
contractor or Salamander Designs.
• Use with products heavier than the maximum weight or other than the cabinet indicated may result
in instability causing possible injury or damage.
• Mounts must be attached as specified in assembly instructions. Improper installation can result in
serious personal injury.
or
3/16” Hex Key (400-060)
1/8” Hex Key (400-070)
CAPACITIES (CONTENT)
SINGLE:
100lbs
TWIN: 100lbs
TRIPLE: 200lbs
QUAD: 250lbs