Salamander Designs JSO/F/CN JumpSeat Ottoman - Manual

Ottoman Wheels
Wheels are included as an option to
the preinstalled feet on your ottoman.
1. Remove the installed feet by removing the screws
from the feet. Do not reuse screws.
2. Using supplied fasteners, fasten wheels to wood
frame of the ottoman. Position steel attachment plate
approximately 3/4” from each edge at the corner.
Doc. No. 501-460 © 2008 Salamander Designs Ltd.
Ottoman Wheels
Wheels are included as an option to
the preinstalled feet on your ottoman.
1. Remove the installed feet by removing the screws
from the feet. Do not reuse screws.
2. Using supplied fasteners, fasten wheels to wood
frame of the ottoman. Position steel attachment plate
approximately 3/4” from each edge at the corner.
Doc. No. 501-460 © 2008 Salamander Designs Ltd.
Ottoman Wheels
Wheels are included as an option to
the preinstalled feet on your ottoman.
1. Remove the installed feet by removing the screws
from the feet. Do not reuse screws.
2. Using supplied fasteners, fasten wheels to wood
frame of the ottoman. Position steel attachment plate
approximately 3/4” from each edge at the corner.
Doc. No. 501-460 © 2008 Salamander Designs Ltd.
Ottoman Wheels
Wheels are included as an option to
the preinstalled feet on your ottoman.
1. Remove the installed feet by removing the screws
from the feet. Do not reuse screws.
2. Using supplied fasteners, fasten wheels to wood
frame of the ottoman. Position steel attachment plate
approximately 3/4” from each edge at the corner.
Doc. No. 501-460 © 2008 Salamander Designs Ltd.
Ottoman Wheels
Wheels are included as an option to
the preinstalled feet on your ottoman.
1. Remove the installed feet by removing the screws
from the feet. Do not reuse screws.
2. Using supplied fasteners, fasten wheels to wood
frame of the ottoman. Position steel attachment plate
approximately 3/4” from each edge at the corner.
Doc. No. 501-460 © 2008 Salamander Designs Ltd.
Ottoman Wheels
Wheels are included as an option to
the preinstalled feet on your ottoman.
1. Remove the installed feet by removing the screws
from the feet. Do not reuse screws.
2. Using supplied fasteners, fasten wheels to wood
frame of the ottoman. Position steel attachment plate
approximately 3/4” from each edge at the corner.
Doc. No. 501-460 © 2008 Salamander Designs Ltd.