Schlage BE469NX User's Guide - Manual (Page 5)

5
ENGLISH
LOCKING AND UNLOCKING
L If you make a mistake while entering a User Code, press the Outside Schlage Button and
start again.
Locking from the Outside
Press the Outside
Schlage Button.
The lock will lock.
L If the Lock &
Leave feature is
disabled, a valid
User Code must
be entered to
lock the door.
See Enable/Disable Lock & Leave on
page 7.
Locking from the Inside
Rotate the Inside
Thumbturn.
L The Inside
Schlage Button
will not lock the
deadbolt.
Unlocking from the Outside
Press the Outside
Schlage Button
and then enter a
valid User Code.
The green success
check mark will
light and the
deadbolt will
unlock.
L If the red error X lights, the User Code
was not valid.
Unlocking from the Inside
Rotate the Inside
Thumbturn.
L The Inside
Schlage Button
will not unlock
the deadbolt.
REPLACING THE BATTERIES
L Replace the batteries in your lock at the same time each year that you test and replace the
batteries in your smoke alarms. This will ensure continued reliable operation.
L Use four high-quality alkaline AA batteries for replacement. Lithium batteries may cause
undesirable operation.
ELECTROSTATIC DISCHARGE
WARNING!
DO NOT TOUCH the circuit board!
You may damage the lock.
1. Remove the inside cover. 2. Unsnap the battery
connector, remove the
battery tray and replace
the batteries.
3. Replace the battery
tray with the batteries
facing the door. Snap
the battery connector to
the tray and replace the
cover.