Securitron SAM2C-24 - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2011, all rights reserved PN# 500-22400
Page 1 Rev. B, 08/11
ADDENDUM FOR MODEL SAM2C-24 MAGNALOCK
This addendum is intended as an introductory supplement to the Securitron Model SAM,
SAM2 Shear Aligning Magnalock Manual (P/N 500-10440) and addresses installation and
operating information specific to the “C” Senstat version of Magnalocks.
1. INTRODUCTION
Securitron has now implemented the new “SAM2C-24”, Form-C style Mini Shear Aligning Magnalock. It
was created to add an additional door status feature. The door status functions when the door is closed
and the Magnalock is under power. The strike contact to the Magnalock face reports a two wire connection
continuity completing door status. The features for the SAM2C-24 are as follows:
 The Form-C feature allows hook-up for door monitoring capabilities
 Dual lock face geometry for lock face isolated contact points
 Field retrofits dimensionally and electrically to its related model types
 Maintains required holding force requirements
 Form-C Operational Specifications: 1 Amp @ 30VDC Maximum
2. ELECTRICAL WIRING
Form-C lock wiring provides isolated closure with the Green and White when the lock is on and the strike is
secure. The wiring diagram is illustrated below.
COM
-
+
NC
SAM2C-24
C
NC
NO
CONTROL
CONTACTS DRY
INCLUDED
DIODE
RED
WHITE
GREEN -
+ 120
VAC
IN
VDC
OUT
24VDC POWER
SUPPLY
NOTE: LOCK IS DEPICTED IN
THE SECURE CONDITION
24VDC OUPUT WHEN LOCK IS SECURE
USE TO ACTIVATE RELAY
FOR DRY CONTACT OUTPUT
3. DOUBLE DOOR STATUS REPORTING
Additional information for “Double Door Status Reporting” can be found in Section 3.6 of the Securitron
Model SAM, SAM2 Shear Aligning Magnalock Manual or in Section 3.6 of the Securitron Magnalock Manual.
4. TROUBLESHOOTING INFORMATION
Additional reference information can be found under “Troubleshooting Information” in Appendix A of the
Securitron Model SAM, SAM2 Shear Aligning Magnalock Manual or in Appendix A of the Securitron
Magnalock Manual.