Securitron SWB-26D - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2011, all rights reserved PN# 500-22200
Page 1 Rev. C, 03/11
INSTALLATION INSTRUCTIONS FOR
SAM WOOD DOOR BRACKET SWB-03, SWB-10B, SWB-26D
1. INTRODUCTION
The SWB – SAM Wood Bracket is designed for various wood door applications. The SWB – SAM Wood
Bracket is designed for use on 1-¾” hard core style doors that include strike mounting applications that
are installed without the use of the end brackets. The SWB – SAM Wood Bracket reinforces the door to
maintain the strength integrity of the door after coring. The SWB – SAM Wood Bracket is available in three
(3) finishes. The finishes are as follows:
SWB-03 Polished Stainless Steel with Brass Finish
SWB-10B Brushed Stainless Steel with Resin Finish
SWB-26D Brushed Stainless with a #4 Grain Finish
2. SPECIFICATIONS
Bracket Dimensions:
Inches: 11”W X 2”H X 1.850”D
Millimeters: 280 W X 51H X 47 D
3. PRODUCT OVERVIEW
Upon unpacking this product, an inventory should be made to ensure that all the required components
and hardware have been included. Along with these Instructions this product should include the following
items:
4. RECOMMENDED TOOLS
Phillips Screwdriver
Drill bit: 9/64”
5. INSTALLATION INSTRUCTIONS
5.1 Door Preparation and Strike Mounting
As expressed in Figure 1, route and chisel the strike mounting area in the door as noted in the
SAM, SAM2 Shear Aligning Magnalock manual Section 2.3.5. Disassemble the end brackets and
screws from the strike and set aside. Parts will not be needed for this installation.
Figure 1 Figure 2
SWB - SAM Wood Bracket
Hardware Pack