Securitron SAM User Manual
Securitron For Home
Securitron Magnalock Corp.
www.securitron.com
ASSA ABLOY, the global leader
Tel
800.624.5625
in door opening solutions
© Copyright, 2012, all rights reserved
PN# 500-10440
Page 1
Rev. F, 02/12
SHEAR ALIGNING MAGNALOCK MODEL SAM
INSTALLATION AND OPERATING INSTRUCTIONS
1 INTRODUCTION
Securitron’s Shear Aligning Magnalock “SAM” is intended for installations where concealed
mounting in the door and frame is desired. The operating features allow self-alignment while
securing the door when it closes. The SAM is designed to operate with one-way swing, bi-
directional swing or sliding type doors. The lock is also capable of securing bi-parting motorized
sliding doors. On swing type doors the lock installs horizontally in the top or bottom of the door
frame or may be installed vertically in the door frame side. For slider type door applications the
locks must be installed horizontally for proper operation. These units have also been designed to
unlock even if a preload is applied to the door.
The SAM BondSTAT “B” Series, Bond Sensor, monitors the magnetic field. An internal sensor
activates a SPDT dry contact relay connection designed for interface to access control and/or
alarm systems for reporting the status of the Magnalock. (See Section 5.6.6)
The DPS “D” Series, Door Position Sensor, is activated by a special magnetic strike armature
assembly. The isolated SPDT reed switch, with an internal resettable protection device, is
designed for interface to access control and/or alarm system for door status. (See Section
5.6.6)
2 SPECIFICATIONS
MODEL
SAM
Holding Force
1200 Lbs [544kg]
Dimensions: Length
10.85" [275mm]
Height
1.5" [38mm]
Depth
1.19" [30mm]
Dual Voltage
12/24 Volts DC
Current: @ 12 VDC
320mA
@ 24 VDC
170mA
Capacitance: @ 12 VDC
6.8mF
@ 24 VDC
6.8mF
BondSTAT Rating
Voltage: 30 VDC (Maximum)
Current: 1 Amp (Maximum)
DPS Rating
Voltage: 30 VDC (Maximum)
Current: 125 mA (Maximum)
3 PRODUCT OVERVIEW
Upon unpacking this product, an inventory should be made to ensure that all the required
components and hardware have been included. Along with these instructions and the
installation template, each product should include the following items:
Figure 1 - SAM Series Magnalock
Magnalock
Strike Assembly
Hardware Pack