Securitron SWK - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2011, all rights reserved PN# 500-22930
Page 1 Rev. B, 08/11
SOLAR WIND KIT MODEL SWK
INSTALLATION INSTRUCTIONS
INTRODUCTION
The Solar Wind Kit is an accessory bracket kit designed to provide a stronger more stable
mounting configuration for PV array panels that are mounted to poles in areas exposed to high
winds. This manual provides the information required to successfully install an SWK to a pole
mounted 10 or 20 Watt PV array panel included with a Securitron solar product.
DESCRIPTION
Function: Included in Kit:
RECOMMENDED TOOLS
 Wrenches: 3/8” and 7/16” (or adjustable)  Phillips Screwdriver: #2
INSTALLATION INSTRUCTIONS
This kit was designed specifically to provide additional support for a pole mounted PV array
panel provided with a Securitron solar product. Please see the solar product installation and
operating instruction manual for the initial installation of the PV array panel and for properly
adjusting the panel to the correct direction and tilt angle.
Note: To ease the installation process the swivel mount brackets already installed to the PV
array panel may need to be repositioned and secured toward the top portion of the panel.
Use Figure 1 and the following step-by-step instructions to install the kit:
 Using the square nuts, flat washers, split lock washers and 10-32 screws, install the two
(2) swivel brackets included with the kit into the side slots toward the lower portion of the
panel as shown in Figure 2.
 Loosely assemble the two (2) support arms to the ends of the cross member using the
provided K-lock nuts, flat washers and 10-32 screws.
 Loosely assemble the cross member to the pole using the U-bolt, 1/4” flat washers and
the 1/4-20 lock nuts provided with the kit.
 Attach the loose ends of the two panel support arms to the previously installed swivel
brackets using the provided K-lock nuts, flat washers and 10-32 screws.
 Verify and if necessary adjust the PV array panel to the correct tilt angle. (See the solar
product installation and operating manual for guidance).
 Ensure that all the components of the kit are properly positioned to support the desired
panel orientation then tighten all hardware to secure the assembly.
1X
2X 2X
2X 2X
1X
6X
2X
6X
4X
2X