Securitron GL1 Quick Start - Manual

Securitron Magnalock Corp. Tel 775.355.5625
550 Vista Boulevard Fax 775.355.5633
Sparks, NV 89434 [email protected]
www.securitron.com
© Copyright, 2007, all rights reserved PN# 500-22120
Page 1 Rev. B, 7/07
ASSA ABLOY, the global leader
in door opening solutions
GL1 QUICK START GUIDE
1) USE SUPPLIED TEMPLATE TO LOCATE AND INSTALL MOUNTING HARDWARE
2) CUT THRU GASKET FOR REAR WIRE HOLE ACCESS IF REQUIRED
3) INSTALL MOUNTING SCREWS - TOP CHASSIS HOLES ONLY!
4) WELD WITHIN PROVIDED CHASSIS SLOTS AND/OR STRIKE PLATE EDGES
5) ROUTE AND CONNECT WIRING - VERIFY OPERATION OF THE LOCK AT THIS POINT
6) INSTALL CAMLOCK AND PLUG IN COVER
7) INSTALL COVER OVER TOP AND SLIDE DOWN INTO POSITION
8) INSTALL COVER SCREWS
9) PLUG CONDUIT FITTING IF NOT USED, WELD PLUG FOR MAXIMUM SECURITY
IF YOU NEED ADDITIONAL HELP REFER
TO TROUBLESHOOTING GUIDE ON
PAGES 14-15 OF "INSTALLATION AND
OPERATING INSTRUCTIONS"