Securitron PB3-LK User Manual

Pb3e/eeb3n (wire side)

Advertising
background image

Securitron Magnalock Corp.

www.securitron.com

ASSA ABLOY, the global leader

Tel

800.624.5625

[email protected]

in door opening solutions


© Copyright, 2011, all rights reserved

PN# 500-15150

Page 1

Rev. E, 08/11


SECURITRON PB3-LK ILLUMINATION KITS

1. INTRODUCTION
The

PB3-LK is

field installable illumination kit intended for the red or green

PB3E/EEB3N

series

push buttons.

2. PRODUCT OVERVIEW
Upon unpacking this product, an inventory should be made to ensure that all the required
components and hardware have been included. Along with these instructions, the PB3-LK
product should include the following items:

Part# Description

PB3-LK

030-11000

2.2V Green LED

1

030-11030

1.9V Red LED

1

540-32060

Green Wire w/ Resistor

1

540-31090 Black

Wire

1

500-15150 Instructions

1


3. INSTALLATION INSTRUCTIONS
Carefully remove the lens from the push button by grasping the small notches on the top and

bottom of lens and pulling straight out. Insert the LED pins into the existing socket. Note the
flat spot at the top of the LED flange as shown in Figure 1. It should point toward the top of the
switch plate. This is important to maintain the polarity of the LED and to prevent any damage.

NOTE: FLAT SPOT ON

TOP OF LED FLANGE

Figure 1

Connect the two wire assemblies by pushing the connectors onto the spade terminals as shown
in Figure 2. Care should be taken to not apply excessive force when sliding the connector over
the pins. Too much pressure may damage the switch. Resistors are installed on the green wire
so that the LED may be operated on either 12 or 24 VDC. If the power supply is 24 VDC,
connect directly to the wires. If the power supply is 12 VDC, remove the outer resistor for

proper operation at the lower voltage. Apply the 12VDC or 24VDC voltage to the green and
black wires to verify operation.

Carefully reinstall the lens onto the front of the push button

switch assembly by pushing on the lens until it clicks into place.

C1

C2

NC1

NO1

NC2

NO2

LE

D

-

LE

D

+

PB3E/EEB3N

(WIRE SIDE)

GREEN WIRE ASSY

540-32060

BLACK WIRE ASSY

540-31090

RESISTORS

Figure 2

Advertising