SecurityMan FlashDVR - Manual (Page 15)

14
Recording Video:
Remove the Waterproof Plug and switch the Main LOCK/ON/OFF Switch to the
ON position. Place the microphone rubber plug (front of FlashDVR) away from
the microphone port for audio recording or vice versa to disable audio recording.
The microphone port is indicated with the microphone symbol. Press the Record
/Stop Button (Fig-2 above) to start video recording. Microphone port must be
plugged in with the waterproof microphone plug for underwater recording, see
Underwater Recording page 15 for detail.
Note: For smooth, stable playback footage; it is best to ensure the FlashDVR is stable during
recording as non-sturdy recording will result in un-stable playback the footages.
A solid blue light will appear for 7 seconds and then flashes blue in the Light
Indicator Window to indicate the DVR is in record mode. Press the Record/Stop
Button again to stop recording at any time. During the initial 7 seconds of solid
blue light recording, the audio will NOT record until the start of the blinking blue
light shown in the Indicator Window. FlashDVR comes with a 4GB built-in
memory. The built-in memory can record up to 2 hours of continuous video
footage in AVI format. Files will be automatically segmented into ~1GB per file,
on an average of 4~5 files for continuous recording until the memory is full.
Day time recording
A fully charged battery last up to 8.5 hours during day time recording without
the use of the LED flashlight. To record in the day, determine the use of the
audio (cover the mic port with the rubber plug to mute or vice versa), set the
recording angle and then press the Record/Stop button once to start recording.
Press the Record/Stop button again to stop the recording.
Night time recording
Night time recording requires the LED flashlight to be turill be shorter in