SKC Battery Pack for AirChek 52 User Manual
Battery pack for airchek 52 sample pumps, Operating instructions, Skc limited warranty and return policy
Use of a repaired or rebuilt battery pack voids any warranty and the UL Listing for intrinsic
safety.
Do not charge or operate pump from charger in hazardous locations!
Use only an SKC-approved charger and battery pack designed for the AirChek
52 Sample
Pump to ensure reliable performance. Failure to do so voids intrinsic safety and any
warranty.
Use of any device other than the approved battery pack to power the pump voids the UL
Listing for intrinsic safety and any warranty.
Failure to follow warnings and cautions voids any warranty.
Battery Pack for
AirChek 52 Sample Pumps
1. To remove a battery pack, loosen two security screws on bottom of pump case
and allow them to fall to the out position.
2. Pinch battery pack release arms and pull the bottom half of the pump case
away from the top half.
3. To install a battery pack, align arms on top half of case with slots on either
side of the new battery pack housing. Ensure the back of the battery pack with
the charging jack is on the same side as the belt clip.
4. Slide battery pack up until arms click into place.
5. Push each security screw into the battery pack housing and tighten.
6. Charge the new battery pack using the charging jack on the back of the
battery pack.
Operating Instructions
863 Valley View Road, Eighty Four, PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]
Batt ery pack
release arms
Batt ery pack
Security
screws in
out position
Form #40062 Rev 1007
Back of Battery Pack
Charging
jack
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which provides
SKC’s sole liability and the buyer’s exclusive remedy. To view the complete SKC Limited
Warranty and Return Policy