Sonnet Technologies Fusion RAID Configuration Tool and Utilities Operation Manual - Manual (Page 66)

ii
Appendix A - CLI ASCII-Based Interface
CLI Error Messages
The following error messages may be returned by the Command
line Interface
ERROR Invalid Command. Type “Help“ for command
list.
ERROR Command Not Processed
ERROR Wrong/Missing Parameters
ERROR Invalid Hot Spare Serial Number
ERROR Invalid RAID GroupName
ERROR Invalid RAID Group State
ERROR Insufficient number of RAID Group members
ERROR RAID Group does not exist
ERROR No RAID Groups found
ERROR Invalid RAID Type
ERROR RAID Group is already unmapped
ERROR Invalid Block Device Index
ERROR Invalid RAID MemberIndex
ERROR Invalid RAID Member State
ERROR Missing RAID Member
ERROR Invalid RAID Member Capacity
ERROR Invalid Partition Index
ERROR Maximum number of RAID Groups exceeded
ERROR Maximum number of Partitions exceeded
ERROR Invalid number of Partitions
ERROR Maximum number of RAID Members exceeded
ERROR Maximum stripe width
ERROR Invalid number of Partitions specified
ERROR Invalid Span Depth specified
ERROR Cannot perform operation on mapped Partition
ERROR Cannot perform operation. RAID Group has
mapped Partitions
ERROR Cannot perform operation. RAID Group has
Outstanding Commands
ERROR Block Device at specified index no longer
available
ERROR Insufficient RAID Group members for RAID
type
ERROR Incorrect number of RAID Group members for
QuickVideo configuration
ERROR Invalid Virtual Drive ID
ERROR Specified capacity is invalid
ERROR Too many Indices specified
ERROR Only one add storage operation is permitted
at any given time
ERROR No free block devices
ERROR Cannot benchmark a drive that is being
initialized
ERROR Specified drive is not being monitored