Sonnet Technologies Fusion D400RAID (With Drives) - Manual (Page 4)

Drive Installation and Enclosure Setup
4
Figure 4
Figure 3
push lever until
it clicks
lever release
button
1. Remove the Fusion drive enclosure and drive modules from
their packaging, and place them near the computer to which the
enclosure will be connected.
2. Take one of the drive modules and push its lever release button
toward the right until the lever pops out. (Figure 3).
3. Carefully slide the drive module into the enclosure until it clicks,
and then push the lever in until it clicks to secure the drive
module inside the enclosure
(Figure 4).
4. Repeat steps 2-3 for each remaining drive module.
Connect Fusion D400RAID Drive Enclosure to Sonnet
RAID Controller
This section describes the connection of the Fusion D400RAID drive
enclosure to the Sonnet RAID controller card.
1. Connect the Infiniband end (with thumbscrews) of the sup-
plied data cable to the Infiniband port on the enclosure; use the
thumbscrews to secure the connector (Figure 5).
2. Connect the mini-SAS end of data cable to a port on the Sonnet
RAID controller card; verify the connector is plugged in securely
(Figure 5).
3. Connect the supplied power cable between the Fusion D400RAID
enclosure and a grounded wall outlet or power strip; verify the
cable is plugged in securely.
4. Push the switch on the back of the enclosure to the on position,
and then power on your computer.
WARNING: When handling computer products, take care to
prevent components from being damaged by static electricity;
avoid working in carpeted areas. Handle the drive modules only by
their edges and avoid touching connector traces and component pins.
WARNING: When inserting drive modules into the enclosure,
do not force the levers closed. If a lever does not close easily,
remove and reinsert the module, and then push the lever in again.
Figure 6
Figure 5
Infiniband
connector
mini-SAS
connector
push module in
until it clicks