Sonnet Technologies Fusion RX1600RAID (Without Drives) - Manual (Page 7)

Enclosure Setup
7
2. Connect each of the data cables’ remaining connectors to either of
the mini-SAS ports on the Sonnet RAID controller card; verify the
connectors are plugged in securely (Figure 15).
3. Connect the supplied power cables between the Fusion
RX1600RAID enclosure and a grounded wall outlet or power
strip;
verify the cables are plugged in securely.
4. Push the power switch on the front of the enclosure, and then
power on your computer.
5. Refer to
Figure 15
mini-SAS
connector
mini-SAS
connector