Sonnet Technologies Echo Express III-R Mobile Rack Kit - Manual (Page 8)

Chapter 3 – Mobile Rack Kit and Device Installation Steps
5. Remove the mobile rack kit from its packaging and set it on a flat, level
surface.
6. Remove and set aside the 16 screws securing the mobile rack cover
plates to the frame (Figure 3). Note that if you are installing a single
half-height device, you only need to remove the eight screws securing
one plate.
7. Set aside the unfastened mobile rack cover plate(s) (Figure 3).
8. Remove the mobile rack devices from their packaging, and then
configure them as necessary.
9. Route interface cables for the mobile rack devices you are installing
through the cable passthrough opening in the mobile rack kit’s frame.
10. Connect the interface cables and appropriate power connectors to the
mobile rack devices:
Connector
Type
Quantity Wire
Molex 88751
or equivalent
SATA
2
Yellow +12V
Black Ground
Red +5V
Black Ground
Orange +3.3V
Molex 8981
or equivalent
3
Yellow +12V
Black Ground
Black Ground
Red +5V
AMP
171822-4 or
equivalent
1
Yellow +12V
Black Ground
Black Ground
Red +5V
Molex
39-01-2040
or equivalent
2
Yellow/
Black
+12V
Black Ground
Yellow/
Black
+12V
Black Ground
Figure 3
4