Sonnet Technologies xMac mini Server 2H - Manual (Page 11)

A – PCIe Cards Installation Steps (continued)
13. Connect one end of the supplied Thunderbolt cable to either one of
the xMac mini Server 2H’s Thunderbolt ports, and then route the other
end of the cable through the external cable passthrough
(Figure 7).
If you are daisy chaining other Thunderbolt devices, plug in the other
Thunderbolt cable into the open Thunderbolt port on the xMac mini
Server 2H.
14. Route any external cables that need to be connected to the computer
(or PCIe cards) through the cable passthrough.
15. Using a Phillips screwdriver, secure the Thunderbolt cable(s) to the
xMac mini Server 2H with the supplied Thunderbolt cable lock
(Figure 7).
16. If desired, secure the cables to the bottom of the xMac mini Server 2H
with cable ties.
B – Mac mini Installation Steps
1. Remove the Mac mini from its packaging.
2. Carefully insert the Mac mini under the top edge of the enclosure, push
it against the gasket behind the enclosure’s face plate, and then lower
the computer onto the floor behind the small plastic posts
(Figure 8).
3. Plug all the xMac mini Server 2H’s cables into the back of the Mac mini,
and other cables into PCIe cards as necessary; verify the cables are
plugged in securely (Figure 8).
Chapter 3 – PCIe Cards, Computer, and xMac mini Server 2H Installation Steps
Figure 7
Figure 8
7