Sonnet Technologies Tempo Ultra ATA66 Host Adapter - Manual (Page 16)

1-4
11. Install the Tempo into the PCI slot.
12. Attach the host connector of the Ultra ATA66
cable to one of the two 40-pin connectors on
the Tempo (see page ix, “Identifying Ultra ATA66
Cable” for further information).
13. Check cable connections; make sure all cables
are properly connected to appropriate locations
on the logic board, Tempo, and hard drive.
14. Carefully replace the case cover onto your
computer. Be careful not to crimp the Ultra
ATA66 cable while replacing the case cover.
15. Turn on the computer.
16. Initialize the newly installed hard drive with
Apple’s Drive Setup utility. It is installed as
part of the Mac OS installation process and is
usually found in the Utilities folder on the
hard drive of your active System Folder.
(See Chapter 3, “Hard Drive Initializing” for
further information.)
Expansion
Card Cover
Ultra ATA66 Cable
When closing the expansion card cover,
avoid crimping the Ultra ATA66
cable on the inner ridges of the cover.
Fold the Ultra ATA66 cable so it fits
within this area.
Figure 3
Support Note: To avoid crimping the
Ultra ATA66 cable on certain desktop-
based Power Macintosh models, carefully align the
Ultra ATA66 cable under the expansion card cover
as illustrated in Figure 3.