Sonnet Technologies Encore_ST G4 1.8 Ghz Processor Upgrade Card - Manual (Page 15)

13
Figure 45
Installation—QuickSilver 001 and 00 Models
Reinstall Fan Assembly and Close Computer
1. Place the fan assembly between the Encore/ST card’s heat sink
and the back panel of the computer, against the modem filter
(Figure 39). Carefully plug in the fan’s 2-pin connector to the
connector on the logic board.
2. With the back of the computer facing you, secure the fan
assembly to the back plate of the computer with the two screws
you removed previously
(Figure 40).
3. Raise the side panel back into place (Figure 41).
4. Return the computer to your computing area if necessary, and
reconnect the power cord and peripheral cables to the computer.
Turn On Computer
Turn on your Power Mac; your accelerated machine should boot
normally.
Qu
ic
kS
ilv
er

00
1/
0
0
screw screw
Figure 39
fan
2-pin
connector
Figure 46
side panel
modem
filter