Sonnet Technologies Encore_ST G4 Duet 1.8 GHz Processor Upgrade Card - Manual (Page 7)

5
Figure 14
Figure 13
screw screw
Installation—AGP Graphics and Gigabit Ethernet Models
5. Take note of the screw visible between the blades on one of the
Duet card’s fans; you will need to secure it (Figure 12).
6. Making sure the Duet card’s captive screws are engaged prop-
erly in the threaded posts, tighten each of the three screws and
secure the card snugly to the logic board;
do not overtighten the
screws (Figure 13).
Close Computer
1. Raise the side panel back into place (Figure 14).
2. Return the computer to your computing area if necessary, and
reconnect the power cord and peripheral cables to the computer.
Turn On Computer
Turn on your Power Mac; your accelerated machine should boot
normally.
side panel
screw
AG
P
Gr
ap
hi
cs
/G
ig
ab
it
Et
he
rn
et
WARNING: When your computer is operating, the Duet’s heat
sink will become VERY hot to the touch; take care to not touch
the heat sink, or you may get burned.
Figure 12
screw
Duet card
fan