Sonnet Technologies PodFreq nano - Manual (Page 2)

D—Play Your Music
Select your music as you would when you listen to your iPod nano
through headphones, and then press play; you will hear the music
through the radio. Because PodFreq nano uses the line level output
signal from the iPod nano, its volume control will have no effect on
the radio’s volume; adjust the volume on the radio.
E—Turn Off PodFreq nano
When PodFreq nano is turned on automatically when you press play
on your iPod nano, it will shut off five minutes after you stop your
iPod. When you turn on PodFreq nano using the Auto Off timer, it
shuts itself off automatically after the time you selected has elapsed.
You may also press the Power button to turn off PodFreq nano
manually.
F—Connect PodFreq nano to Your Computer
PodFreq nano is a dock when you connect it to your computer with
the included mini-USB cable. You can sync your iPod nano with
iTunes, transfer files between your computer and iPod nano; your
iPod nano’s battery will also charge while PodFreq nano is con-
nected to your computer. You may charge your iPod nano through
PodFreq nano’s FireWire connector (FireWire cable required, sold sep-
arately), but file transfer and iTunes sync features are not supported.
Troubleshooting
Problem What to Check
Power button and display
backlight are not lit
To save power, the Power button’s light and display backlight
shut off ten seconds after PodFreq nano turns on; this is nor-
mal operation.
Weak reception • Antennas - Verify PodFreq nano’s antenna is fully extended,
and if you’re using a portable radio, make sure its antenna is
also fully extended.
• Distance - Try moving PodFreq nano closer to the radio. The
effective transmitting range will decrease with distance;
objects and walls between PodFreq nano and the FM tuner
or radio's antenna will also affect reception.
• Radio station on the same frequency - If there is a radio station
broadcasting on the frequency you chose, reception will be
affected; this is especially important to remember when you
use PodFreq nano in a moving vehicle.
• Strong adjacent radio station(s) - The presence of a strong
radio station on a frequency near the one you’ve chosen
(problematic in and near larger cities) may cause interfer-
ence; try selecting another frequency.
Distorted sound • Different tuning frequencies - Verify that PodFreq nano’s
broadcast frequency is the same as the one you chose on
the FM tuner. If you are using an analog tuner, try fine-tun-
ing the dial to hear clearer sound.
• iPod nano EQ is on - When any EQ setting other than Off is
selected on iPod nano, especially any setting that increases
the bass, the sound from iPod nano may be distorted.
Unfortunately, this is normal, as the distortion may also be
heard through the headphones; this is an iPod nano issue.
Choose the EQ Off setting for the best sound quality.
FCC Compliance
PodFreq nano complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: This device may not cause
harmful interference, AND this device must accept any interference
received, including interference that may cause undesired operation.
B—Find an “Empty” Station on the FM Band
Find an FM frequency between 88.1 and 107.9 on your radio or
tuner’s FM band that has no radio station broadcasting on it, or
when that’s not possible, find the one with the weakest radio station
broadcast.
C—Set Up PodFreq nano to Broadcast
1. Pull up the antenna on the back of PodFreq nano until it is
fully extended.
2. Turn on PodFreq nano; there are two ways to do this:
• Press and release the play button on your iPod nano; PodFreq
nano’s power button and display backlight will light up for
approximately 10 seconds, and then turn off. Please note,
PodFreq nano turns on automatically along with your iPod
nano. If there is no output from your iPod nano for five min-
utes, PodFreq nano will shut itself off.
• Press and hold the Power button until “Auto
Off” appears on the display, followed by
“1hr”, “2hr”, “3hr”, “4hr”, or “8hr”; release
the button when you choose the number of hours you want
PodFreq nano to remain on. The Power button light and display
backlight will turn off 10 seconds after you first press the button.
3. Using the Up and Down tuning buttons,
tune PodFreq nano to the same frequency
you chose on your radio. If the radio you are
using has digital tuning, be sure to select the exact same num-
ber. Otherwise, the sound quality will be affected. For instance,
the sound quality may be poor if you select 93.2 on PodFreq
nano when your radio is tuned to 93.3.
Limited Warranty
Sonnet Technologies, Inc. warrants that this product shall be free
from defects in materials and workmanship for a period of one
year following the date of original purchase. For complete warranty
information, go to www.podfreq.com.
Contacting Customer Service
The Sonnet web site located at www.sonnettech.com has the most
current support information and technical updates.
Before you call Sonnet Customer Service, please check our web site
for the latest updates and online support files, and check this user’s
guide for helpful information. When you call Sonnet Customer
Service, have the following information available so our customer
service staff can better assist you:
• Product name • Date and place of purchase • iPod model
If further assistance is needed, please contact us at:
Sonnet Customer Service:
Tel: 1-949-472-2772
(Monday–Friday, 7 a.m.–5 p.m. Pacific Time)
Fax: 1-949-457-6350
E-mail: [email protected]
Online Service Form: http://serviceform.sonnettech.com
Visit Our Web Site
For the most current product information and online support files,
visit the Sonnet web site at www.sonnettech.com. Remember to reg-
ister your product online at http://registration.sonnettech.com to be
informed of future upgrades and product releases.
©2006 Sonnet Technologies, Inc. All rights reserved. Sonnet, the Sonnet logotype, Simply Fast, the Simply Fast logotype, PodFreq,
and the PodFreq logotype are trademarks of Sonnet Technologies, Inc. Macintosh, Mac, iPod, and iTunes are trademarks of Apple
Computer, Inc., registered in the United States and other countries. Other product names are trademarks of their respective own-
ers. Product specifications subject to change without notice. Printed in the USA. UG-FMT-IPOD-NANO-A-033006
Support Note: Unlike many other products, the iPod nano’s
line level output signal is affected by its EQ settings. You may
want to experiment with various EQ settings to achieve the best sound
quality, as some settings which increase bass may introduce distortion;
Sonnet recommends that the iPod nano’s EQ be set to Off.