Harrington Hoists and Cranes ED 1050 Supplement - (ED3) User Manual
Page 11
Advertising
11
Table 5-5
Top Hook & Bottom Hook Dimensions
“k” Measured When New:
Top: _________________________
Bottom: ______________________
Capacity
(lbs)
*Nominal "k"
Dimension
inch (mm)
"u" Dimension
inch (mm)
"t" Dimension
inch (mm)
Standard
Discard
Standard
Discard
1050
1.65(42)
0.93(23.5)
0.83(21)
0.69(17.5)
0.63(16)
* These values are nominal since the dimension is not controlled to a tolerance. The "k"
dimension should be measured when the hook is new - this becomes a reference
measurement. Subsequent measurements are compared to this reference to make
determinations about hook deformation/stretch. See
EDOM Section 5.7
, “Hooks - Stretch”.
Advertising