Harwin Z1002-00 - Manual

IS-06 Issue: 4 Date: 31/03/2011 C/Note: 11215 Page 1 of 2
TRACK PIN INSERTION TOOL Z1002-00
HARWIN
This Insertion Tool has been designed for use with the following track pins:

T1559-46

T1563-46
TO LOAD TOOL
1. Ensure that the first track pin on the strip is straight and in line. If not, gently bend into
alignment.
2. Insert the strip of pins into the plastic feed tube until resistance is felt. The tapered end of
the pin should be inserted first
3. Depress thumb knob several times to index pins fully, until one protrudes below the
insertion head. If pins will not index, rotate pins in plastic tube until flexing occurs.
4. For optimum snap-off, adjust the screw hexagonal nose on the insertion head, i.e. the head
of the pins just protrudes below the level of the screw.
5. The tool is now loaded and ready to use.
Harwin North America Harwin Europe Harwin Asia
T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868
E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com
Index pin
forward