Harwin Z80-258 User Manual
General information, Care of tool, Advice on use
IS-28 Issue: 3 Date: 01.12.08 C/Note: 10212
Page 1 of 2
EXTRACTION TOOL Z80-258
This Extraction Tool has been designed for use with the following Datamate Trio-Tek Signal Crimp
Contacts and Crimp Housings:
M80-25300XX.............. Female crimp contact for 22-24 AWG wire, supplied reeled
M80-25400XX.............. Female crimp contact for 26-28 AWG wire, supplied reeled
M80-28300XX.............. Female crimp contact for 22-24 AWG wire, supplied loose
M80-28400XX.............. Female crimp contact for 26-28 AWG wire, supplied loose
M80-454XX98.............. Female crimp housing, no jackscrews
M80-455XX98.............. Female crimp housing, Hexagonal slotted jackscrews
M80-456XX98.............. Female crimp housing, Hexagonal Socket jackscrews
M80-457XX98.............. Female crimp housing, Reverse Fix jackscrews
M80-458XX98.............. Female crimp housing, Guide Pin with Panel Mount jackscrews
GENERAL INFORMATION
The Extraction Tool consists of a single metal flat tool – the probe referred to in the following
instructions is the small rectangular protrusion. This tool can also be used to aid assembly of the
contacts into the housings, if required, by using the end of the probe to push on the back of the
crimp contact.
CARE OF TOOL
When the tool is not in use, store the tool in a clean, dry area. Avoid leaving anywhere where
the blade may become damaged or twisted.
ADVICE ON USE
Manual tools such as this extraction tool are intended for low volume use. Repetitive,
high-volume use is not recommended.
Use only with the Trio-Tek crimp contacts and housings listed above.
This tool is designed for hand use only, and must not be used with clamping, fixturing or use of
handle extensions.
If you have any questions about this instruction sheet, or the Trio-Tek range of Datamate
connectors, please contact
.
Harwin North America
Harwin Europe Harwin
Germany
Harwin
Asia
T: +1 603 893 5376
T: +44 (0) 23 9231 4545
T: +49 (0) 89 3791 9400
T: +65 6 779 4909
E:
Probe
Tool handle