Harwin Datamate S-Tek - Manual (Page 3)

ASSEMBLY PROCEDURE FOR S-TEK BACKSHELL ADAPTORS
Harwin North America Harwin Europe Harwin Asia
T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 386
E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com.sg
IS-32 Issue: 4 Date: 01.04.11 C/Note: 11172 Page 3 of 4
Fig.1
Fig.2
6) Once braiding has been terminated as described and shown on page 2, and the locking lip is
positioned as recommended, the Datamate connector can be positioned into the backshell housing
ready to receive the jackscrews as shown below. Ensure moulding is pushed fully into backshell prior
to fitting the jackscrews.
7) With the Datamate connector correctly positioned in the metal backshell, the jackscrews can now be
inserted from the rear of the backshell as shown below. Ensure that Datamate connector remains
fully inserted into backshell and using your finger and thumb support the jackscrews. Visually inspect
the connector and backshell assembly to ensure the ‘E’-clip groove in the jackscrews is visible.
8) Using Harwin tool Z80-300 apply ‘E’-clips to the jackscrews:
a. The picture right shows the ‘E’-clip groove in the tools tip this
must be face down on surface when engaging clips with tool.
b. Position clip as shown in fig.1 it is recommended all ‘E’-clips are
placed on a flat surface and a square block is used to push clip
against to engage tool. Slide the tool flat along the surface to
engage the ‘E’-clip.
c. Once the clip is engaged with the tool, ensure that the clip is
orientated correctly as shown in fig.2.