Hochiki HCP-EM - Manual (Page 2)

2-3-0-635/ISS6/SEPT12
fig 4 fig 5
fig 6 – HCP-E(DPS) additional wiring fig 7
Replace the non-frangible element (yellow strip to
top). Place the cover over lower half of unit so that
the tabs inside the cover line up with the grooves
on the sides of the main unit (see fig 7). Then
slide the cover up back into place until it clicks shut
(see fig 8).
TESTING
To test the call point insert the supplied test key
into the aperture at the bottom of the unit until the
lower cover opens. The non-frangible element will
drop, thus simulating operation of the call point
(see fig 1). To reset the unit remove the key and
fig 8
slide the lower cover up (with the non-frangible element) back into place until it clicks shut (see fig 8).
RESETTING AFTER ACTIVATION
To reset the call point after it has been activated, insert the supplied test key into the aperture at the bottom of
the unit until the lower cover opens, remove key. If a glass element has been used, remove cover, replace
glass element and replace cover. Then slide the lower cover up (with the element) back into place until it clicks
shut (see fig 8).
HCP-E, HCP-EM, HCP-E(DPS) 0832-CPD-0601 07 EN54-11 Manual Call Points
HCP-E(SCI) 0832-CPD-1238 09
EN54-11 Manual Call Points
EN54-17:2005 Short-Circuit Isolators
Hochiki Europe (UK) Ltd
Grosvenor Road, Gillingham Business Park,
Gillingham, Kent, ME8 0SA, England Telephone:
+44(0)1634 260133 Facsimile: +44(0)1634 260132
Email: [email protected]
Web: www.hochikieurope.com Hochiki Europe (UK) Ltd. reserves the right to alter the
specification of its products from time to time without notice.
Although every effort has been made to ensure the accuracy of
the information contained within this document it is not warranted
or represented by Hochiki Europe (UK) Ltd. to be a complete and
up-to-date description. Please check our web site for the latest
version of this document.
Protocol specified in TI/006