Hochiki HCP-WM - Manual (Page 2)

2-3-0-750/ISS4/NOV09
Wire the loop cables as per the wiring diagrams shown below (see figs 6 and 7). The loop connections must not be
greater than 2.5mm
2
cable diameter for proper fixing to the terminal blocks. If required, cable screens can be
terminated at the earth terminal within the back box (see fig 4).
Once connected fix the front section of the unit call point to the back box, pushing the two halves together to
engage clips. At this point ensure the gasket seal is intact and in place (Note: The gasket should be replaced when
refitting or replacing the Water Cover). Fix the four cover screws (see fig 1).
fig 5 fig 6
TESTING
To test the call point insert the supplied test key into
the aperture at the bottom of the unit until the lower
cover opens. The non-frangible element will drop,
thus simulating operation of the call point (see fig 8).
To reset the unit after testing remove the key and
slide the lower cover up (with the non-frangible
element) back into place until it clicks shut (see fig 9).
fig 7 – HCP-W(DPS) additional wiring
fig 8 fig 9
RESETTING AFTER ACTIVATION
To reset the call point after it has been activated, insert the supplied test key into the aperture at the bottom of the
unit until the lower cover opens, remove key. If a glass element has been used, remove cover, replace glass
element and replace cover. Then slide the lower cover up (with the element) back into place until it clicks shut (see
fig 8).
HCP-W, HCP-WM, HCP-W(DPS) 0832-CPD-0602 07 EN54-11 Manual Call Points
HCP-W(SCI) 0832-CPD-1239 09
EN54-11 Manual Call Points
EN54-17:2005 Short-Circuit Isolators
Hochiki Europe (UK) Ltd
Grosvenor Road, Gillingham Business Park,
Gillingham, Kent, ME8 0SA, England Telephone:
+44(0)1634 260133 Facsimile: +44(0)1634 260132
Email: [email protected]
Web: www.hochikieurope.com Hochiki Europe (UK) Ltd. reserves the right to alter the
specification of its products from time to time without notice.
Although every effort has been made to ensure the accuracy of
the information contained within this document it is not warranted
or represented by Hochiki Europe (UK) Ltd. to be a complete and
up-to-date description. Please check our web site for the latest
version of this document.