IAI America RCS2-A6R - Manual (Page 32)

2. Installation
26
[2] Handling in Assembled Condition
This is the case when the product is delivered from our factory under a condition that it is assembled
with other actuators. The combined axes are delivered in a package that the frame is nailed on the
lumber base. The rods are fixed so they would not accidently move. The actuators are also fixed so
the tip of it would not shake due to the external vibration.
(1) How to Handle in Package
� Do not hit or drop the package. No special treatment is conducted on this package to
endure a drop or impact on it.
� Do not attempt to carry a heavy package with only one worker. Also, have an appropriate
method for transportation.
� When hanging up with ropes, support on the reinforcement frame on the bottom of the
lumber base. When bringing up the package with a forklift, also support on the bottom of
the lumber base.
� Handle with care when putting the package down to avoid impact or bounce.
� Do not step on the package.
� Do not put anything on the package that could deform or damage it.
(2) How to Handle after Unpackaged
� Fix the rod so they would not accidently move during transportation.
� If the tip of an actuator is overhanging, have an appropriate way to fix it to avoid shake due
to the external vibration. In the transportation without the tip being fixed, do not apply any
impact with 0.3G or more.
� When hanging up with ropes, have appropriate cushioning to avoid any deformation of the
actuator body. Also keep it in stable horizontal orientation. Make a fixture utilizing the
attachment holes and the tapped holes on the actuator body if necessary.
� Do not attempt to apply load on the actuators or the connector box. Also pay attention not
to pinch cables and bend or deform them forcefully.
[3] Handling in Condition of being assembled in Machinery Equipment (System)
This is some caution notes for when transporting the actuator being assembled in the
machinery equipment (system).
� Fix the table so they would not move during transportation.
� If the tip of an actuator is overhanging, have an appropriate way to fix it to avoid shake due
to the external vibration. In the transportation without the tip being fixed, do not apply any
impact with 0.3G or more.
� When hanging up the machinery equipment (system) with ropes, do not attempt to apply
load on the actuators or the connector box. Also pay attention not to pinch cables and bend
or deform them forcefully.