IAI America SSPDACR - Manual (Page 85)

14. Motor Replacement Procedures
77
(5) Removing the motor unit
[1] Loosen the coupling tightening bolt.
Caution: If the actuator is installed
vertically, exercise due caution
not to let the slider drop.
Hold the slider (work part) from
the outside to prevent it from
dropping, and then loosen the
coupling bolt.
(2) Remove the bolts used to secure the motor using an Allen wrench of 4 mm across flats, and pull out the
motor unit and coupling from the motor housing.
Body Motor
Motor
Motor affixing bolt Motor affixing bolt
Motor affixing bolt Motor affixing bolt