IDEC MicroSmart Pentra User Manual
Pid module, Fc5a
Advertising
Table of contents
Document Outline
- 1: GENERAL INFORMATION
- 2: MODULE SPECIFICATIONS
- 3: INSTALLATION AND WIRING
- 4: PID MODULE MAIN FUNCTIONS
- 5: DEVICE ALLOCATION OF PID MODULE
- Device Allocation of PID Module
- Program Size
- Valid Devices
- Control Register
- Control Relay
- Data Register Allocation - Block 0 Read Only Parameters
- Data Register Allocation - Block 1 Write Only Parameters
- Data Register Allocation - Blocks 2, 3 Basic Parameters (SHOT Action)
- Data Register Allocation - Blocks 4, 5 Initial Setting Parameters (SHOT Action)
- Data Register Allocation - Blocks 10-19 CH0 Program Parameters (SHOT Action)
- Data Register Allocation - Blocks 30-39 CH1 Program Parameters (SHOT Action)
- 6: CONFIGURING PID MODULE USING WINDLDR
- Procedure to configure the PID module
- Expansion Modules Configuration Dialog Box
- PID Module Configuration Dialog Box
- PID Module Configuration - Input Parameters List (CH0 and CH1)
- PID Module Configuration - Control Parameters List (CH0 and CH1)
- PID Module Configuration - Output Parameters List (CH0 and CH1)
- PID Module Configuration - Program Parameters List (CH0 and CH1)
- PID Module Configuration - I/O Function Selections
- PID Module Configuration - Input Parameters Details
- PID Module Configuration - Control Parameters Details
- PID Module Configuration - Output Parameters Details
- PID Module Configuration - Program Parameters Details
- Monitoring PID Module
- 7: APPLICATION EXAMPLES
- 8: TROUBLESHOOTING
- The PID Module Power LED (PWR) is OFF or Flashing.
- The PID Module output does not operate normally.
- Hunting phenomenon is occurring while in ON/OFF control action
- Hunting phenomenon is occurring while in PID, PI, PD, or P control action
- The PID Module input does not operate normally.
- Loop break alarm turns on even though the actuator operates normally.
- Program control is terminated earlier than the configured time.
- 9: APPENDIX