IDEC DATAVS1 Series - Manual (Page 46)

Instruction Manual SVS1 Series
41
We can acces the Adjust mode by pressing the STATUS button. Let's increase the acceptance
threshold slightly using the ARROW UP button.
Now press the STATUS button to enter Monitor Mode and check that the tool functions properly.
As the result is satisfying, press STATUS again and move on to defining the behaviour of the
outputs.
Let's associate output 1 to the Part Pass behaviour and output 2 to the Toggle behaviour (leaving
output 3 disabled). Press TEACH to save the modifications.
Now let's save the bank on the sensor. Enter the Bankset menu and save the inspection in
memory bank 1.
Press the ESC button to return to Monitor mode.