Sending the configuration to the portable device – IntelliTrack Check In/Out User Manual
Page 57
Chapter 2
Device Setup
47
7.
Press the Save button on the Tool bar to save the setting.
8.
The configuration needs to be sent to the device. See
figuration to the Portable Device” on page 47
for more information.
After it is sent to the device, the key may be used to perform the ESC
function in IntelliTrack RF.
Sending the
Configuration
to the
Portable
Device
Once you have configured the Generic Options, the VT options, and if
applicable, the ESC function, you are ready to send the settings to your
portable device. Your portable device must be connected to your PC via
ActiveSync or Windows Mobile Device Center to send the files to the por-
table device. Please refer to the steps that follow for an outline of this pro-
cedure.
1.
To send the configuration files to the portable device, go to the Wireless
Telnet Main Screen and select the Install Configuration Only button.
(If SofToGo is not installed on the device, click the Install Program +
Configuration button to send both the SofToGo application and the RF
Telnet configuration files to the device.)