Inter-M HDMS-0808 - Manual (Page 6)

VIDEO AUDIO MATRIX SWITCHER
4 HDMS-0808
Front Panel Front Panel
1. DISPLAY WINDOW
Displays the video input channel status which is output to each video/audio output terminal.
“1”~”8” shows each channel, and if “0” is displayed, nothing will be output.
2. INPUT/OUTPUT SELECT BUTTON
- Output : select the channel you want to output. Push this button, and then display window of corresponding
channel will blink. If the input channel to be output is selected while blinking, display window will
change to the corresponding input channel and blinking will stop.
After start blinking, selection will be cancelled if there is no input for about 10 seconds.
- Input : select the input channel to be output to each output terminal.
3. ALL/OFF BUTTON
- ALL : select all output channels. If push this button, display windows of all channels will blink. After start
blinking, selection will be cancelled if there is no input for about 10 seconds. ALL buttons are used
when you want to output one channel in all outputs or disconnect all outputs.
- OFF : it is used when disconnect the output channel. After selecting the OUTPUT SELECT button, push OFF
button, and then display window shows “0” and nothing will be output.
4. MODE SELECT BUTTON
Sets up the mode status of No. 2 and 3 SELECT SWITCH.
- A/V : it sets up No. 2 and 3 SELECT button mode status to simultaneous control mode of Video and Audio.
- Video : it sets up No. 2 and 3 SELECT button mode status to Video Control Mode.
- Audio : it sets up No. 2 and 3 SELECT button mode status to Audio Control Mode.
5. LOCK BUTTON
It is the button to prevent the human error. After all channel settings are completed, click this button for 5
times, and then all buttons on the front will not work while LED of buttons will be displayed.
To unlock, push it for 5 times again, and then LED will be OFF. Lock function will not be cleared even after
turning off the power and turning it on again.
1
6
2 4 5 3