ION Audio WATER ROCKER - Manual (Page 5)

5
WIRELESS AUDIO SETUP
Transmitter
1. Raise the audio player cover and pull out the Aux in cable
2. Connect the 3.5mm stereo plug to the line out or headphone out jack of your external audio device play your
external audio device
3. Press the Aux in cable retrieval button on the back of the transmitter and adjust the aux in cable to the desired
length
4. Place your audio device on the audio player platform and close the audio player cover.
5. Turn on the transmitter by sliding the power switch to the ON position. The Tx (transmit) status LED will change to
Green to indicate the signal is transmitting. If the Tx status remains in RED, increase the volume level of your
external audio device. Once sufficient audio level is detected, the Tx Status will change to Green. If you
experience static or interference, try changing the channel on the transmitter
Speaker (receiver)
1. Press the POWER button on the speaker
2. Press the Fn (function) button to select wireless receiving mode. The wireless indicator will blink on the display
3. Once a signal has been received, the wireless indicator will stop blinking and remain steady. If no signal is
received, move the speaker closer to the transmitter as you may be out of the 90 foot transmission range
4. Adjust the desired volume level using the VOL +/- buttons.
5. Repeat steps 2-4 to sync additional speakers to the transmitter.
Secondary Aux In
You can also connect an audio device to the transmitter by using RCA type cables (not included) to the RCA stereo
jacks:
1. Connect an external audio device to the transmitter by using RCA audio cables
2. On the front of the Transmitter, unplug the 3.5mm cable if this is connected to an external audio device
Note: If both the front Aux in and rear RCA input jacks are receiving audio, both signals will be transmitted
3. Turn on the external audio device
4. Follow steps 1-5 from the above Speaker (receiver) section.
Frequency Scanning
There are three frequency channels to select from to avoid interference and find the best reception.
1. Select a channel on the transmitter using the Channel Selector button
2. From the speaker, press the SCAN button and transmitter will match with the new channel automatically
Auto-Shut-Off
If no signal is received by the speaker, the wireless indicator will blink and after about 4 minutes the speaker will
automatically turn off.
RADIO TUNER OPERATION
Radio Tuning
1. Press the Power button to turn on the speaker
2. Press the Fn button to select FM radio receiving mode
3. Press the ST/MO button to switch to FM stereo or mono receiving mode
4. To manually tune to a station, press the TUN +/- button
5. To automatically search for stations with a strong signal near you, press and hold the TUN +/- button until the
frequency digits on the display begin to scan, and then release the button. The tuner will stop at the first strong
signal it finds
Storing Radio Preset Stations
WATER ROCKER can store up to 20 FM stations in its memory for easy recall at any time:
1. Press the Power button to turn on the speaker
2. Press the Fn button to select FM radio receiving mode
3. Tune to the station that you want to store in memory using the TUN +/- buttons
4. Once the station is found, press the MEM button and the preset channel number will blink on the display
5. To select a preset station number, press the CH +/- buttons
6. To save to the preset location, press the MEM button
7. Repeat steps 3-6 to store more stations
Note: if no command is given within a few seconds, the display will go back to the radio receiving mode.
Recalling Radio Preset Stations
1. Press the Power button to turn on the speaker
2. Press the Fn button to select FM radio receiving mode
3. To select the desired preset station, press the CH +/- button