Features, Using the dj splitter cable – ION Audio iDJ 2 Go User Manual
Page 4
4
Features
1.
30-PIN DOCK CONNECTOR – The 30
pin connector provides power to iDJ2GO
from the connected iPad, iPhone, or iPod
touch.
2.
PFL – Sends pre-fader audio to the Cue
Channel for monitoring.
3.
CUE GAIN – Adjusts the audio level of
the Cue channel.
4.
MASTER VOLUME – Adjusts the output volume of the Program mix.
5.
BROWSE KNOB – Turn this knob to scroll through lists of tracks and directories in the app.
6.
BACK – This button will take you back to the previous level (folder).
7.
ENTER – When this button is pressed, a track is selected and loaded onto the respective deck.
8.
LOAD A / LOAD B – Press the LOAD A / LOAD B buttons to bring up the music menu for the respective
decks.
9.
CHANNEL VOLUME – Adjusts the audio level on the corresponding channel.
10.
CROSSFADER – Blends audio playing between Decks A and B. Sliding this to the left plays Deck A and sliding
to the right plays Deck B.
11.
JOG WHEEL – Moving the JOG WHEEL "scratches" on the track on that deck – an effect similar to moving the
platter on a turntable. To engage Pitch Bend Mode, hold the LOAD A / LOAD B button for two seconds; when
the deck is playing, the JOG WHEEL will bend the track's pitch.
12.
PLAY / PAUSE – Starts or resumes playback if the Deck is paused. Pauses playback if the Deck is playing.
13.
CUE – The CUE button will return and pause the track at the last set cue point. For temporary play of the cue
point, you can hold down the CUE button. The track will play for as long as the button is held down and will
return to the cue point once it has been released. You can hold down CUE and PLAY / PAUSE simultaneously
to start playback from the cue point. Release both buttons to allow playback to continue.
14.
SYNC – Automatically matches the corresponding Deck's tempo with the other Deck's tempo.
15.
PITCH FADER – Controls the track's playback speed.
16.
PITCH BEND ( + / - ) – Press or hold down either of these buttons to temporarily adjust the track's playback
speed. When released, the track playback will return to the speed designated by the PITCH FADER.
Using the DJ Splitter Cable
With the DJ splitter cable connected to your device, you can cue audio
from one deck in your headphones independent from what is heard from
the master output. The red output cable sends the cued signal and the
black output cable sends the master output. If a replacement DJ splitter
cable is needed, contact the ION Audio Parts Dept. at
ionaudio.com/support.
Using the DJ splitter cable with the iDJ2GO app:
1.
Connect the DJ splitter cable to the headphone jack on your
device.
2.
Open the iDJ2GO app.
3.
Click on the cogwheel to open Settings and select the Right
channel under DJ’s Headphone.
4.
Select the DJ Splitter Cable graphic under Output/splitter.
5.
In the app’s main screen, select which deck you want to cue in your headphones.
Using the DJ splitter cable with Algoriddim’s djay app:
1.
Connect the DJ splitter cable to the headphone jack on your device.
2.
Open Algoriddim’s djay app.
3.
The Split Output Enabled dialog box will appear. Press OK to continue.
4.
Cue your tracks using the headphone cue buttons.
1
2
14
15
16
16
4
14
3
5
6
7
8
8
9
9
10
11
12
12
13
13
13
11
15
2