ION Audio Pics 2 PC - Manual (Page 5)

3
DRIVER AND SOFTWARE INSTALLATION
To use the PICS 2 PC you must first install
the drivers and software. Both of these
items can be found on the included CD.
1.
Turn on the computer.
2. Insert the installation CD into the CD-
ROM drive and the installation menu will
appear. *
3. When you see the installation menu,
click Install Driver.
4. Follow the on-screen instructions.
5. When the driver installation is complete,
click BlazePhoto to install the software.
6. Follow the on-screen instructions.
7. If your computer does not have DirectX
9.0 or greater or Adobe Reader, click
those items to install them. (If your
computer is using Windows XP Service
Pack 2 or higher, Windows Vista, or
Windows XP Professional, this is not
necessary.)
8. Click Exit to close the window.
Note: The first time you connect PICS 2 PC to your computer, wait a few seconds until you see a dialog box
that says "Found New Hardware" (this means the computer recognizes the PICS 2 PC). After you see this,
PICS 2 PC is ready to use.
USING THE INCLUDED HOLDERS
SLIDE & NEGATIVE HOLDERS
1.
Open the holder.
2.
Put the slides / film into the holder.
3.
Close the holder and please make sure the holder
closes properly.
PHOTO HOLDERS
1.
Slide your photo into the top slot of the appropriate
holder:
3.5" x 5"
4" x 6"
5" x 7"
2.
To remove the photo, simply turn the holder upside-
down and let it slide out.
* If the installation menu does not appear automatically,
open My Computer and double-click your computer's
CD drive to open the disc then click the "autorun"
application.