Jackco Power Post Model 892 - Manual (Page 5)

SET UP
Suggestion: install a pressure gauge (not included) on your pump to indicate a relative level of pulling
force.
1. Secure the threaded ram to bottom of power post, then connect ram to air pump with hydraulic hose
provided.
2. Slide the pull chain thru the chain pulley, idle pulley and power lever arm.
3. Secure the safety chain on chain pulley to an anchor pot.
Note: The dual chain helps to divide the pull force exerted by the post and also allows positioning the
post between two anchor pots.
OPERATION
Safety Message! Operate equipment from at least 6 feet from either side of post and chains.
1. Adjust the chain pulley (# 21) to desire height to pull using the handle bar.
2. Secure the pull chain before pulling object.
3. To operate, activate air pump or use the hand pump until desire height or position is reached. Always
monitor pressure and load. Use caution when nearing this maximum operating ram pressure.
Caution! Never operate pump with release valve closed and disconnected from ram. If operated in this
condition, the hose and connections become pressurized. This increases burst hazard. Damage may
occur to pump and its components
Figure 2 - Illustrations of Common Applications
4