Jackco Model 842 - Manual (Page 3)

INSTRUCTION
PRODUCT DESCRIPTION
-10,000 PSI AIR Hydraulic Pump designed to operate @90-120 PSI air source.
-This equipment allows quick displacement of hydraulic fluid up to 1600 c.c/97 cu.in..
-Foot pedal design delivers a smooth, controllable flow to and from the intended
application.
SPECIFICATION
Capacity Pump Size (L x W x H) Usable Volume Oil Oil Outlet Size
10,000 PSI 10” x 5.6”x 8.3” 1600c.c./97 cu.in. 3/8 NPT
IMPORTANT
1. Check for leaks in the system and repair as needed. Before repairs are made, disconnect
air inlet and hydraulic connection, then depressurize reservoir. Do so simply by depressing
the pedal for a few seconds.
2. Replace worn / damaged parts and assemblies with original new parts.
3. Use adequate eye protection when operating or near this equipment.
4. Check connections before use.
OPERATION
1. Pull up the air-vent before use.
2. Connect to a hydraulic cylinder, then to air source of at least 100 PSI, and then depress
foot pedal slowly until motor starts to move.
3. Operate pump until desired position is reached. To stop, release pressure on the pedal.
4. To retract, simply press down on the “RELEASE” portion of the foot pedal.