Jackco Model 65500 - Manual (Page 3)

To Lower a vehicle:
1. Slowly turn handle knob (#3-8) counter-clockwise. Speed of descent is controlled
by amount release valve is turned.
To Lift a Vehicle:
OPERATING INSTRUCTION
3
1. Turn handle knob (#3-8) clockwise until resistance is felt to close release valve.
Do not over-tighten.
2. Place jack directly under object to be lifted. Make sure saddle takes up weight
firmly and centrally. Check positioning under slight load to confirm jack or load will
not slip.
3. Raise jack by pumping handle until desired height is reached. After lifting, secure
load by appropriate means. Do not use jack as the only means of support.
Important: Sometimes during shipment and handling, air gets into the hydraulic
system, causing poor lifting performance. Before initial operation, purge any air from
the system by fully opening release (Turn handle knob (#3-8) counter-clockwise).
Then, while holding the saddle down, pump pedal (#3-2) rapidly several times.
SPECIFICATION
Capacity: 5 Ton Lift Range : 16.1 inch
Max Height : 22 inch Gross Weight 222 lbs
Min Height : 5.9 inch Net Weight : 191 lbs