Janam XM66 - Manual (Page 7)

Getting Started
XM Series Quick Start Guide Page 6
A. CALIBRATING THE SCREEN
The fi rst time the device is turned on, the Welcome Utility appears. To set up the device, follow the
on-screen instructions using the stylus to tap the exact center of each target
Note: If your XM Series device came pre-loaded with a custom software application, the Welcome Utility
may not appear.
B. ATTACHING THE HANDSTRAP
To attach the handstrap, fi rst align the two holes in the metal handstrap anchor at the two handstrap screw
ports. Then, for each side, place one of the screws provided into a lined up screw hole/screw port and turn
clockwise. Secure both sides before fully tightening down the screws.
Separate velcro to extend the handstrap and feed loose end through the handstrap bar. Fasten velcro
together to close the strap. Fit strap and secure device to user’s hand by adjusting velcro as needed.