JuiceGoose PD1B - Manual (Page 2)

GENERAL WIRING DESIGN
The PD1-A and PD1-B products in-
cludes multiple, single phase, 20 amp
circuits and therefore multiple “hot”
and “neutral” wire leads. A common
ground connects all outlets and the
chassis, unless otherwise specified at
the time of order. The “hot” leads are
distinguished by the color of the wire
used. The layout of the circuitry is
specified at the time of order. The
designation of the circuits begins
with the outlets nearest the place
where the wire harness exits the
chassis. These outlets are connected
to the black wire lead which is con-
sidered “Circuit #1“. Outlets for
each succeeding circuit are attached
to a different color lead in order as
follows:
Red
Yellow
Blue
Orange
Violet
Brown.
All “neutral” leads are white. All
ground leads are green. The exact
configuration of the wiring is deter-
mined by the specifications commu-
nicated with the purchase order.
INSTALLATION
The PD-ONE chassis is designed
with three mounting brackets: one
top, one bottom and one midway on
a side. The PD1-B, because of its
lesser length does not have a side
bracket. All three brackets on the
PD1-A should be used to mount the
unit to a stable surface using appro-
priate hardware such as a #10 machine
screw and nut.
The PD1 is not an “all weather” device.
The surface to which the PD1 is mounted
should be stable and protected from mois-
ture and temperature extremes.
CAUTION
This PD-ONE is intended for commercial
use only and is to be installed only by a
qualified electrical technician. Installation
or use in any manner inconsistent with this
documentation or with customary practice
or local wiring code may cause serious
damage or injury. If a malfunction is ob-
served or suspected, disconnect this de-
vice from AC power immediately and con-
tact Juice Goose or an electrical techni-
cian.
Each circuit in the PD1 is rated at 20
amps. All wiring and components have
maximum current ratings of 20 amps. Do
not exceed this capacity. Do not discon-
nect, rewire or replace any components.
SPECIFICATION
The internal and external wiring of the
PD1 is 12AWG THHN. The length of
the external wire harness is specified
with the purchase order. The electrical
receptacles are NEMA 5/20R. All
components are UL recognized.