JuiceGoose XVRT Series - Manual (Page 9)

9
any equipment while UPS conducts self-test; await it until the Power indicator
lights up. Besides this, switch on your equipment after the UPS is switched on..
3.6 Battery auto-charging
Once the power cord is connected, the battery of the UPS will be automatically
charged by the UPS..
3.7 Overload protection
If an overload situation is detected during the self-test, UPS audible alarm will
activate, emit a long beep and automatically shut down the system. Unplug at
least one piece of equipment from the Battery Supplied Outlets. Switch off UPS,
wait 5 seconds and check to make sure the circuit breaker is set then switch on,
again.
3.8 Optimal battery status
To maintain the optimal status of battery, make sure the UPS remains plugged in..
3.9 Self-protection feature
UPS is equipped with a self-protection feature preventing people users from
damaging the unit. It is programmed so that once switched off, the user must wait
5 seconds before switching UPS on again.
3.10 Storage
To store UPS, cover it and store it with the battery fully charged. During extended
storage, recharge the battery every three months to ensure battery life.
3.11 Power failure
When the event of power failure occurs after turning on UPS, and prior to the
self-test sequence, UPS will automatically shut down and not restart until utility
power is restored. This is necessary to check the quality of power that is delivered
to your connected equipment.
3.12 Installation with accessories of “Rack-mount” types:
Please install the rack-mount type units according to the following
illustration.
1 0
Installation with bottom plate.
Part
RMB-08 (1U),
RMB-09 (2U),
RMB-10 (3U),
RMB-11 (4U)
2 PCS.
Installation with bottom
bracket.
Part
RMB-12 (1U~4U)
2 PCS.
Installation with rear
bracket
Part
RMB-13,
RMB-14 (2U-4U)
4 PCS.
Step 1
Step 1
Step 1