KB Electronics Multi Speed Board - Manual (Page 9)

III. MOUNTING INSTRUCTIONS
See Figure 7 on page 6. Note:
Figure 7 is also supplied as a sep-
arate drawing.
WARNING! Make
sure all power is
disconnected from the KBMG
before proceeding.
A. Removing the KBMG Finger-
Safe Cover – If a finger-safe
cover is not installed on the
KBMG, proceed to Section III
B. If a finger-safe cover is
installed on the KBMG,
remove the two (2) socket
head 5-40 X 1/4” screws
located at the rear of the
KBMG using the supplied
3/32” hex key. Also, remove
the two (2) 6-32 X 1
3 ⁄
4
” screws
located on either side of
Terminal Block TB1 of the
KBMG. See Figure 8.
7
!
KBMG
Finger-Safe
Cover
KBMG
5-40 x 1/4"
6-32 x 1-3/4"
Screws
FIGURE 8 – REMOVING THE KBMG FINGER-SAFE COVER